Re: [reSIProcate-users] Basic Repro Setup

[Bryan Nations <bnations@xxxxxxxxxxxxxxx>]

Ok so I changed  DisableAuthInt = true and it solved that problem, now when I try to dial it just times out, I'm sure I'm missing something simple here, I also tried to call without any routes and it say service temporarily unavailable.

So I add the routes like this:

^sip:100@REPRO\.PUBLIC\.IP\.ADDRESS			sip:100@xxxxxxxxxxxxxxx.ADDRESS	0
^sip:101@REPRO\.PUBLIC\.IP\.ADDRESS			sip:101@xxxxxxxxxxxxxxx.ADDRESS

And when I try to call it just times out.

Here is the repro.log file:
http://pastebin.com/kSXcveyL

Here is the repro.config file:
http://pastebin.com/k9EEjVY6

Thanks again for the help,
Bryan

On 6/13/2015 8:59 PM, slgodin@xxxxxxxxx wrote:

Just read the old post - if you suspect this is the problem, you can disable auth-int authentication in repro config file.

Scott

Sent from my iPhone

On Jun 13, 2015, at 9:05 PM, Bryan Nations <bnations@xxxxxxxxxxxxxxx> wrote:

Hello all,
Im new to Resiprocate and am trying to set up a very simple scenario where I register 2 users via soft phone to repro (100, 101) respectively. The routes defined respectively. I am able to register both users but when I try to dial either 100 or 101 I get a 403 authentication failed message.

I see another member ran into the same problem here:
http://list.resiprocate.org/archive/repro-users/msg00370.html

But Im not sure if he ever resolved the issue.

Any help would be appreciated,
Thanks
_______________________________________________
resiprocate-users mailing list
resiprocate-users@xxxxxxxxxxxxxxx
List Archive: http://list.resiprocate.org/archive/resiprocate-users/