[reSIProcate] why the basic message cannot register to repro server over ipv6

["tonyxuqi" <tonyxuqi@xxxxxxx>]

Hi,all
      I tried to test the feature function of repro over ipv6. The repor was compiled with pre-compile USE_IPV6 and HAVE_OPT_H. And it is run with IPV6 enabled. So basic message project was also compiled with pre-compile USE_IPV6 and HAVE_OPT_H. The parameters are as follows:
    sip:aaa@[2001:da8:8000:3:0:5efe:202.120.54.8] aaa xxx reaml sip:yimolasa@[2001:da8:8000:3:0:5efe:202.120.54.8]
 But the log message shows that there's one error when register to repro server , its code is 10047. I look up the msdn,it means Address family not supported by protocol family. So i was confused that whether the basic message project support ipv6, or the parameters i input are not well formated, or some other reasons.
   BTW, i use the ISATAP to get the ipv6 address.
   Thank you very much!


Best regards!
                       TonyXu

  已有1亿用户选择了网易邮箱，你呢？
  网易163免费邮已全面升级至2000兆超大空间，支持收发超大附件！